14
Pandora Immo
WARNING!
FACTORY PRESET PIN-CODE SHOULD BE CHANGED BE-
FORE USING THE DEVICE. KEEP IN MEMORY OR WRITE
YOUR NEW PIN-CODE AND DO NOT PLACE IT IN OR NEAR
YOUR CAR.
It is recommended to put system into maintenance mode before handing
it to the car service or valet parking. When this mode is switched on, security
system stops interfering with built-in electronics and disables all functions
to ease maintenance or parking. Moreover, you will not have to leave
immobilizer tag to the valet or the mechanic. This mode can be activated
via programming menu, app or immobilizer tag. Active maintenance/valet
mode is confirmed with 1 beep. Deactivation of this mode is confirmed with
2 beeps.
1. Programming menu:
Enter PIN-code (see ‘PIN-code input’, page 20). Correct PIN-code will be
confirmed with 6 beeps for 5 seconds. Immobilizer tag will be temporary
deactivated until the ignition is switched off. If PIN is incorrect, incorrect
entering ringtone (PIN-code is incorrect) will sound.
To permanently deactivate the tag, activate maintenance/valet mode
(see ‘Enabling maintenance/valet mode, page 17).
2. Immobilizer tag:
Place the tag in radio coverage zone, switch on the ignition and wait for
detection tag ringtone. To enable maintenance/valet mode, press and hold
tag’s button until LED indicator will flash 3 times, then release the button.
Disabling procedure is similar to enabling one.
3. Mobile app.
‘Enabling of maintenance/valet mode’ detailed description on page 17.
WARNING!
IF THE TAG’S BATTERY IS DISCHARGED/ABSENT OR THE
TAG IS DEFECTIVE, MAINTENANCE/VALET MODE CANNOT
BE ENABLED VIA IMMOBILIZER TAG.
