22
Pandora Immo
WARNING!
THE SYSTEM SUPPORTS WORK UP TO 3 TAGS.
WARNING!
AFTER PROGRAMMING THE FIRST TAG, ALL PREVIOUS
TAGS AND RADIO RELAYS WILL BE PURGED FROM SYS-
TEMS MEMORY AND WILL NEED TO BE PROGRAMMED
AGAIN IN THIS PROGRAMMING SESSION.
2. Maintenance mode activation.
To proceed to maintenance/valet mode, switch off the ignition when the
second signal sounds.
Exit this mode via immobilizer tag or mobile app.
3. Deleting of mobile device from the system’s memory.
To proceed to this mode, switch off the ignition when the third signal
sounds.
WARNING!
THIS PROCEDURE SHOULD BE PERFORMED AFTER THE
SYSTEM’S INSTALLATION IF ADDITIONAL SETTINGS WERE
CARRIED OUT VIA APP OR THE SYSTEM IS PASSED TO THE
NEW OWNER.
4. PIN-code changing.
To proceed to this mode, switch off the ignition when the fourth signal
sounds.
PIN-code consists of 4 digits, factory preset PIN is 1-1-1. Avoid occasional
pauses that can prevent correct procedure when entering new PIN-code.
Switch on the ignition. ‘Enter PIN-code’ ringtone will sound once (the first
digit of the new code entering) after that 10 beeps will sound. Switch off
the ignition immediately after the signal with the number that matches the
first digit of the new code. The first digit of new PIN-code will correspond to
the number of beeps from 1 to 9 when the ignition is switched on, zero will
correspond to the switching off the ignition after tenth beep.
Switch on the ignition. ‘Enter PIN-code’ ringtone will sound twice (the
