20
Pandora Immo
INSTALLATION AND CONFIGURATION OF THE SYSTEM
Programming system
PIN-code input
Use PIN-code for emergency deactivation and access to immobilizer
settings. PIN-code entering is performed via switching on/off the ignition.
Remove the tag from the immobilizer radio coverage zone or remove
battery from the tag. Switch on the ignition and wait for the termination of
warning signals, in several seconds after the ignition is switched on, ‘Enter
PIN-code’ ringtone will sound once (the first digit entering). If the ignition
was switched on repeatedly, when the tag is lost, warning signals will not be
emitted (the system will proceed to enter the first digit), after that 10 beeps
will start sounding. Switch off the ignition immediately after the signal with
the number that matches the first digit of the PIN-code. Switching off the
ignition after the first beep will correspond to the digit ‘1’ and after tenth
one – to the digit ‘0’.
Switch on th ignition, ‘Enter PIN-code’ ringtone should sound twice (the
second digit entering), then 10 beeps will sound. Switch off the ignition
immediately after the signal with the number that matches the second digit
of PIN-code.
Switch on the ignition, ‘Enter PIN-code’ ringtone should sound three
times (the third digit entering), then 10 beeps will start sounding. Switch off
the ignition immediately after the signal with the number that matches the
third digit of PIN-code.
Switch on the ignition. If PIN-code is incorrect, ‘PIN-code is incorrect’
ringtone will sound, the system will return to the beginning of PIN-code
entering procedure. If PIN-code is correct, six 5-second-long beeps will
sound.
