21
User manual
Pandora Immo
Programming menu
Tags programming
mode
Maintenance/valet
mode
Deleting of mobile device
Changing
PIN-code
Reserved
Update
the software
The first beep
5 sec.
Entering new PIN-code
The 1st
digit
The 2nd
digit
The 3rd
digit
1.
The second beep
5 sec.
2.
The third beep
5 sec.
Single beeps
Press and hold
button for 6 sec.
Confirming new PIN-code
The 1st
digit
The 2nd
digit
The 3rd
digit
Double beeps
3.
The fourth beep
5 sec.
4.
The fifth beep
5 sec.
5.
The sixth beep
5 sec.
Exit programming
mode
6.
Exit programming
mode
1. Program immobilizer tags.
To proceed to the tags programming mode, switch off and then on the
ignition when the first signal sounds.
When the ignition is switched on, searching for tags procedure will be
performed. Insert batteries into the tags, then press and hold control button
on the tag until LED indicator flashes 6 times (6 seconds), then release the
button. If procedure was performed correctly, beeper will emit 1 beep.
Perform this procedure for the second and the third tags. Pause between
recording tags into the system’s memory is limited (up to 2 minutes). To finish
programming procedure, switch off, then on the ignition.
