Panasonic YF-0201Z5HGF, Руководство по эксплуатации, Страница: 21 / 38

Basic operation
21
4.2.5
Adjustment and Test run
（ 1 ） Adjustment
• Press “ADJ.” key, then “CH1”
is displayed on the “Data
indicator B”.
• Pressure is being applied
while the foot switch is kept
on.
（
2
）
Test run
• Press “TEST” key, then “CH2”
is displayed on the “Data
indicator B”.
• Turn on the foot switch to
execute a series of welding
sequence without applying
welding current.
4.3
Starting the welding operation
Prior to operation, completion of
welding conditions settings.
（
1
）
Press RUN key.
（ 2 ） Press WELD key
（ 3 ） Turn ON the foot switch.
（
4
）
After completion of
welding, indicators show
welding results.
The welding results shown
in the figure are,
• Job No.: 2
• SOL No.: 1
• Welding current 1:
10 cycles, 12,000 A
（
5
）
It is possible to change
display indication by
pressing the ENTER/
SHIFT key.
See “Switching display indication” for the order of
indication change.
Note
Do not turn off the “CONTROL POWER” while “START” input is
in ON state. (If this occurred, turn ON the CONTROL POWER
within 24 hours.) If this occurred, counter values of monitoring
items (welding count, production count and step up count) are
reset to the values before turning on the start input, therefore,
indicators do not indicate the actual values, which is not treated
as an error.
1
2
Adjustment
↓
Test run
DEG.
x1
x100(A)
%
x1
DEG.
x1
x100(A)
%
x1
1
2
4
5
Switching display indication
<Initial display>
• Welding cycle
• Welding current
<Press “ENTER/SHIFT” key>
↓
• Conduction angle
• Welding current
<Press “ENTER/SHIFT” key>
↓
• Welding count
• Number of production
<Press “ENTER/SHIFT” key>
↓
• Number of step-ups
• Remaining welding count
<Press “ENTER/SHIFT” key> to return to the initial
display.
DEG.
x1
x100(A)
%
x1
DEG.
x1
x100(A)
%
x1
DEG.
x1
x100(A)
%
x1
DEG.
x1
x100(A)
%
x1