１０
FEEL SAFE TO USE IT.
REMOTE CONTROLLER
The remote controller is fixed to the wire feeder.
PREPARATIONS
Scale Plate
Both sides of the plate is used properly,
depending
on
a
type
of
setting;
INDIVIDUAL or
SIMPLE UNIFIED.
When SIMPLE UNIFIED is selected (select
on the printed circuit board: refer to
Page 25),reverse the scale plate for use.
Welding Current Control
Pressing this switch feeds the welding wire.
Although a feed rate can he adjusted with the
adjacent welding current control, select a
low speed because the wire tends to buckle as
its diameter decreases.
The wire can be only fed out.
(It cannot be wound in. )
Scale Plate Fixing Bolt
Capable of adjusting a welding
current value.
Note) When SIMPLE UNIFIED is
selected, the welding voltage is
internally processed so that it
automatically
assumes
an
appropriate value with respect to
a set current value. This is
called simple unification)
Welding Current Control
Capable of adjusting a welding voltage.
Note) When SIMPLE UNIFIED is selected (refer to page
25). It works as a fine control for the simple unified
welding voltage. With this control being at a
standard position, the welding voltage may not be an
optimum condition, depending on a welding posture,
wire brand, and length of the extension cable, wire
projection length. If this is the case, the welding
voltage can be finely adjusted "lower" by turning
this control to the left, and
“
higher
”
by turning to
the right.
