2.6.2.4 Configure settings relating to HTTP alarm notification when an
alarm occurs
Click “HTTP alarm notification setup >>” of “Camera action on alarm” on the [Alarm] tab of the “Alarm” page.
(
Refer to page 108 for information on configuration for these settings.
2.6.3 Configure the VMD settings [VMD area]
Click the [VMD area] tab on the “Alarm” page. (
®
For menu display and how to operate, refer to page 34,
page 34)
The video motion detection areas can be set on this page.
Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.
IMPORTANT
•
The alarm occurrence indication button (
®
page 12) will be displayed when motion is detected by the
VMD function.
•
The alarm occurrence indication button will be displayed at an SCD alarm occurrence or when receiving
a command alarm as well.
•
Depending on the network environment, notification may be delayed even when “Real time” is selected
for “Status update mode” on the [Basic] tab of the “Basic” page (
•
After configuring the VMD area, the VMD area may move out of alignment when “Image capture
mode” of the [Image] tab is changed. Make sure to check the VMD area after changing the “Image
capture mode” setting.
•
Note that VMD does not function in the area where the privacy zone is set.
98
Operating Instructions
2 Settings
