![background image](http://html.mh-extra.com/html/panasonic/wv-ns950-series/wv-ns950-series_setup-instructions_277926035.webp)
35
• When selecting "Zone No" after selecting "Gray" for
"Mode", a mask will be displayed at the center of the
image display area and will start blinking while
changing its colour as follows.
Dark gray
→
Clear
→
Light gray
→
Clear
→
Dark
gray...
When the other mask that had already been set is
on the same zone, the mask that had previously
been set will blink as follows.
Dark gray
→
Light gray
• When selecting "Zone No" after selecting "Mosaic"
for "Mode", a mask will be displayed at the center of
the image display area with a mosaic effect.
When the other mask that had already been set is
on the same zone, the mask that had previously
been set will be displayed in dark gray.
ZOOM buttons
FOCUS buttons
BRIGHTNESS buttons
Control pad/buttons
Refer to Operating Instructions for descriptions of how
to operate these buttons/pad.
[PRESET]
Select from registered preset items.
[GO] button
The camera moves to the selected preset position.
[CLOSE] button
Click this button to close the "Privacy zone" setup menu.
Configure the settings relating to audio [Audio]
Click the [Audio] tab on the "Camera setup" page. (
☞
pages 4 and 5: How to display/operate the setup menu)
The settings relating to audio can be configured on this page.
[Audio mode]
Select the communication mode used for audio data
transmission/reception between the camera and the PC
from the following.
OFF:
Does not receive/transmit audio between the cam-
era and the PC. Therefore, the settings and controls
relating to audio will be invalidated.
Mic input:
The PC receives audio data from the cam-
era. Audio can be heard with images on the PC.
Images and audio will not be synchronized.
Audio output:
Audio data from the PC will be transmit-
ted to the camera. Audio can be heard from the
speaker connected to the camera.
Interactive (half duplex):
Both reception and transmis-
sion are available. However, audio data cannot
simultaneously be transmitted and received.
Interactive (full duplex):
Both reception and transmis-
sion are simultaneously available.
Note:
Howling may be generated depending on usage
conditions. If howling is generated, prevent sound
generated by the PC from entering the PC micro-
phone.
Default:
OFF
Note:
When "Multicast" is selected for "Transmission type"
of "MPEG-4 setup" in the "MPEG-4 setup" section of
the [JPEG/MPEG-4] tab of the "Camera setup" page
(
☞
page 21), it is impossible to carry out the "Audio
output" operation while monitoring MPEG-4 image.
To carry out the "Audio output" operation, click the
[JPEG] button.
[Audio bit rate]
Select "16 kbps" or "32 kbps" for the audio bit rate used
to transmit/receive audio data.
Default:
32 kbps