16
Installation
Precautions
• Make sure that the place you are installing the camera is strong enough to support it. If it is not strong enough,
then the camera may fall and hurt someone.
• The following steps of installation and connection work should be done by qualified service personnel or
system installers and should conform to all local codes.
• Be sure to turn the power off before installation and connection.
• Do not install the camera near the air outlet of an air conditioner.
■
Mounting the Camera
Wall mount
The figure shows an example of the camera mounted on
a wall with the optional WV-Q122 Wall Mount Bracket.
See instructions included with the optional bracket
●
Construction
STEP 1
Attach the camera to the housing base, and secure the
camera and the housing base with the mounting
screws (x3).
The screws that are removed need to be used during
reassembly. Be careful to not lose them.
* Special screw (mounting screw)
Use a hexagon wrench for the hexagon screw (M5).
STEP 2
To detach the housing base, turn the camera clockwise
to the end, viewed from the bottom.
(Ø
58)
(60)
25
85
40 1-1/2A deep 30 MAX
PT11 crest (parallel pipe thread)
40 1-1/2B deep 30 MAX
PT11 crest (taper pipe thread)
300 mm
REAR
Screws (x3)
Housing Base
Camera
START
LOCK
START
LOCK
Housing Base
Camera
REAR
Ceiling mount
The figure shows an example of the camera mounted
on a ceiling with a locally procured bracket.
Refer to the instructions included with the bracket for
filling gaps and holes with waterproof material.
Note:
• When removing the front and rear sun shields,
perform steps 5 to 7 in the reverse order.
Important:
• When using this mount bracket, the hexagon screws
(M6) that are accessory of the brackets cannot be
used as the mounting screws for this camera. Use
the hexagon screws (M5) attached to the housing
base.
