Panasonic WV-CS400, Руководство по эксплуатации

Страница: 18 / 29

- 15 -
Line-lock Sync Mode (LL)
• Display the Setup menu.
• If necessary, refer to Setup Menu Display, for details on displaying the
Setup menu on the monitor screen.
• Move the cursor to the "SYNC" mode position and select the line-lock
"LL" mode by using the Joystick. This setup can be only made when
the multiplexed vertical drive (VD2) pulse is not supplied to the
camera.
• After confirming that the cursor is on the "LL" position, press the CAM
(SET) Button on the rear panel. The following vertical phase
adjustment menu is then displayed on the monitor.
• Move the cursor to the "COARSE" mode position by using the
Joystick. The cursor starts blinking.
• Connect the video output signal of the camera to be adjusted and the
referenced camera video output signal (for example, Camera 1) to the
dual-trace oscilloscope.
• Set the dual-trace oscilloscope to the vertical rate and expand the
vertical sync portion on the oscilloscope.
• Control the Joystick to match as closely as possible the vertical
phases for both video output signals. (The coarse adjustment can be
incremented for every 22.5 degrees (16 steps) by the Joystick.)
** SET UP **
CAMERA ID OFF *
ALC/MANUAL ALC *
SHUTTER OFF
AGC ON
SYNC LL *
WHITE BAL ATW *
AUTO PAN OFF
SPECIAL *
Camera setting menu
** SYNC **
V PHASE
COARSE 1(1---16)
FINE .I.......
−
+
RET
** SYNC **
V PHASE
COARSE 1(1---16)
FINE .I........
−
+
RET
Camera setting menu
↓
1 (1 - - - 16): 0 degree
2 (1 - - - 16): 22.5 degree
↑
16 (1 - - - 16): 337.5 degree
Note: After the 16 steps, the adjustment returns to the first step.
• Move the cursor to the "FINE" mode by using the Down Switch.
The cursor starts blinking.
• Use the Joystick to match as closely as possible the vertical phases
for both video output signals. (Fine adjustment can be made for up to
22.5 degrees by using the Joystick.)