![background image](http://html.mh-extra.com/html/panasonic/wv-clr930/wv-clr930_operating-instructions-manual_277790041.webp)
41
**MODE1**
LEVEL ···I···255
- +
DWELL TIME 2S
DISPLAY MODE
O
ALARM OFF
MASK SET
O
RET TOP END
**CAMERA SETUP** 1/2
CAMERA ID OFF
O
ALC/ELC ALC
O
SHUTTER OFF
AGC ON
O
SENS UP OFF
SYNC INT
WHITE BAL ATW1
O
MOTION DET OFF
DNR HIGH
RESOLUTION HIGH
BW MODE
O
Advanced settings about motion detector function (MODE1)
The description below specifies the sensitivity level and detection area of the motion detector
(MODE1).
To perform mask setting, set the image stabilizer, i.e. "STABILIZER" to "OFF". (
☞
page 47)
"MODE 1" screen
Mask setting screen
"CAMERA SETUP" screen
Step 1
Set "MOTION DET" to "MODE1" and press the
setting button.
→
The "MODE1" screen appears.
Step 2
Move the cursor to "MASK SET" and press
the setting button.
→
The mask setting screen appears.
Step 3
Perform mask setting. The operation proce-
dure is the same as the masking operation in
the process of "Sensing area setting for
backlight compensation". (
☞
page 30)
Step 4
Hold down the setting button for approx.
more than 2 seconds after completion of
masking.
→
The "MODE1" screen appears again.
Step 5
Move the cursor to "ALARM", and decide
whether or not to provide an alarm signal in
the demonstration mode with use of "ON" or
"OFF".
ON:
Provides an alarm signal output in the
demonstration mode, and allows users to
check the operation on the monitor when
a motion is detection.
OFF (default):
Provides no alarm signal out-
put in the demonstration mode.