Move the cursor horizontally to adjust the
horizontal phase with use of the right or left
button.
Adjustable range: 0 to –2.0 µs
Step 5
Move the cursor to "SC COARSE" (subcarrier
coarse adjustment), and use the following 4
steps to match the real color of the subject
with the color of the effect output signal (pro-
gram output video signal) of the special
effect device (SEG) with use of right or left
button.
1 (1--4) : 0 °/2 (1--4) : 90 °/3 (1--4) : 180 °/
4 (1--4) : 270 °
Step 6
Move the cursor to "SC FINE" (subcarrier fine
adjustment), and move the cursor horizontal-
ly with use of the right or left button to match
the real color of the subject with the color of
the program output video signal.
Notes:
• When the cursor moves to the right end
"+" position, the cursor moves to the left
end "-" position. At the time, the setting
value of "SC COARSE" is incremented by
1, and adjustment is continuously per-
formed.
• Holding down the right or left button for
more than 1 second increases the cursor
moving speed.
• To achieve high precision adjustment,
provide the video signal of the camera
and program output signal to a vector
chromaticity indicator to compare the
macro phases of both signals.
36
**SYNC**
H PHASE ···I···128
- +
SC COARSE 1(1--4)
SC FINE ···I···128
- +
RET TOP END
"SYNC" screen
Adjustment of phase in VBS genlock mode (VBS)
The adjusting video signal of the camera and the criterial external synchronizing input signal
are connected to a 2-input oscilloscope and the phase is adjusted. Follow the procedure below
to adjust the phase.
**CAMERA SETUP** 1/2
CAMERA ID OFF
O
ALC/ELC ALC
O
SHUTTER OFF
AGC ON
O
SENS UP OFF
SYNC INT
WHITE BAL ATW1
O
MOTION DET OFF
DNR HIGH
RESOLUTION HIGH
BW MODE
O
"CAMERA SETUP" screen
Step 1
Provide a VBS signal to the external synchro-
nizing input connector on the rear side of the
camera.
→
The "SYNC" setting automatically
changes to "EXT (VBS)".
Step 2
Move the cursor to "EXT (VBS)" and press the
setting button.
→
The "SYNC" screen appears.
Step 3
Connect the video output signal and external
synchronizing input signal of the camera to a
2-input oscilloscope, and move the cursor to
"H PHASE".
Step 4
Adjust the oscilloscope to the horizontal rate,
and extend the horizontal synchronizing part
of the oscilloscope.
