105
DP-2330/3030
DEC 2004
Ver. 2.0
DP-2310/3010
4.2.3.
Fax Service Mode 1 (Function Parameter Setting)
Use the following procedure to change the function parameters.
Select the "01 Function Param. Setting" on the Touch Panel display.
↓
Select the desired code number on the Touch Panel display.
↓
If you wish to select another code number, scroll the menu with the arrow buttons.
↓
Select the desired function on the Touch Panel display and touch the "OK" button.
↓
Touch the "OK" button 3 times.
↓
Press "FUNCTION" and "C (CLEAR)" keys simultaneously to exit the service mode.
Function Parameter Table
No.
Parameter
Selections
Function
000 Monitor/Tel Dial 1 = Monitor
2 = Tel/Dial
Selects whether the machine starts to TX
automatically during On-Hook dialing.
Monitor
: Start to TX after pressing START
TEL/DIAL
: Start to TX automatically
001 Alarm Status
1 = Off
2 = Timer
3 = Constant
Selects the No Paper or No Toner alarm status.
OFF
: Alarm is disabled.
Timer
: Alarm will shut off after 6 seconds.
Constant
: Alarm will not stop until "STOP" is
pressed or the error is cleared/
corrected.
002 Stop Comm.
JRNL
1 = Off
2 = On
Selects whether the machine prompts to print the
COMM. Journal when the printout condition is set to
INC and STOP is pressed during communication.
003 Continuous Poll 1 = Off
2 = Stn (Tx only)
3 = Hub (Rx only)
Selects whether the Continuous Polling feature is
enabled.
Stn
: Place the document(s) on the ADF or Platen,
then press the assigned Program Key to store
or add the documents into a polled file. (See
Note 1)
Hub
: When the polling command is initiated, the
machine will continuously poll originals from
the remote stations until it is interrupted by
pressing "STOP".
004 Numeric ID Set
1 = Off (will not accept)
2 = On (accepts)
Selects whether the machine accepts and allows to
set or change the Numeric ID.
Содержание Workio DP-3010
Страница 134: ...134 DP 2330 3030 DEC 2004 Ver 2 0 DP 2310 3010 memo ...
Страница 311: ...311 DP 2330 3030 DEC 2004 Ver 2 0 DP 2310 3010 memo ...
Страница 312: ...E ...