21
How to detach the front panel (operating
section)
Step 1
When detaching the front panel (operating section) while the
power is on, hold down the [ALARM RESET] button and the
[MONITOR] button (for more than 2 seconds).
→
The indicators on the front panel (operating section) will
go off.
Step 2
Open the maintenance port cover and the DVD drive cover,
and then remove the fixing screws (x3).
Step 3
Pull the right side of the front panel (operating section) first,
and then detach the front panel (operating section).
Step 4
Disconnect the connection cable of the front panel (operat-
ing section).
• Detach the cables from the cable clamp on the front
panel (operating section).
• Disconnect the cable while holding down the tab of the
connector.
DVD drive cover
Maintenance port cover
(Pull up the bottom side
of cover.)
Connection
cable
Connector
Cable clamp
Note:
• Before disconnecting the cable, make sure that the indi
-
cators on the front panel (operating section) are off.
How to attach the front panel (operating sec-
tion)
Step 1
Connect the connection cable of the front panel (operating
section).
When connecting the connection cable, make a coil with
cable and pass the cable clamp through the coil.
(
☞
Reference illustration for step 4 of "How to detach the
front panel (operating section)")
Step 2
Put the tab (on the left of the front panel (operating section))
into the hole, and then attach the front panel (operating sec-
tion).
Step 3
Secure the front panel (operating section) using the
detached screws (x3).
Tab
Hole
