Panasonic VL-W1-N Series, Руководство по установке и обслуживанию

Страница: 158 / 176

158
„
Display/Configuration
Troubles Causes Measures
Touch panel console
shows nothing.
Laser welding machine has not been
started.
See remedial action against “Start-up”.
Cable of the touch panel is not
connected.
Check that the cable is connected to connector
[CONSOLE] on front of controller.
Return harness is not connected.
Connect return harness to [RETURN OUT], [VGA
OUT] and [(VGA+RETURN) IN] on the rear of the
controller.
Touch panel console
does not respond to
screen tap.
Return harness is not connected.
Connect return harness to [RETURN OUT], [VGA
OUT] and [(VGA+RETURN) IN] on the rear of the
controller.
Monitor shows nothing.
Monitor is not turned on. Check power to monitor.
Monitor cable is not connected.
Check that monitor cable is securely connected to
connector [VGA OUT] on rear of controller.
The connected monitor is not applicable
with the laser welding machine.
Connect a VGA-compatible monitor.
Mouse does not work.
The mouse is connected to the USB
hub.
Connect the USB mouse to the laser welding
machine controller directly without USB hub.
The mouse type is not supported by
the laser welding machine.
Use the USB mouse with Human interface device
(HID) class.
A USB flash drive cannot
be recognized.
• A USB flash drive with a security
function is used.
• The file system selected when
formatting the USB flash drive is not
appropriate.
• The connector of the USB flash
drive is dirty.
• The laser welding machine was
launched with the USB flash drive
connected.
• USB flash drives with a security function
cannot be used.
• Use a USB flash drive formatted with FAT32.
• Clean the connector according to the
procedure in the instruction manual of your
USB flash drive.
• Insert the USB flash drive after the activation
of the laser welding machine is completed.
ME-VLW1N-SM-1