Panasonic VL-W1-N Series, Руководство по установке и обслуживанию

Страница: 43 / 176

43
2-3 Head Installation
WARNING
• Make sure that the power is turned OFF at installing. Failure to do so may cause
electrical shock.
• Install the product so that the laser beam path does not cross the eye height.
• The laser beam path shall be enclosed with protective enclosure and make sure
it is not exposed with direct light or reflected light.
2-3-1 Installation direction
Install the head to the following directions.
Horizontally with the laser
emission port facing downward
Horizontally with the laser
emission port facing upward
Vertically with the rear of
the head facing upward
ワㄐㄕㄊ㄄ㄆ
• Do not move the head unit during the operation.
• Be sure to fix the bottom surface (the laser emission port side).
• When the head is installed with the laser emission port facing upward, dust may attach to the laser emission port,
impairing processing quality and damage the product. Clean the laser emission port periodically according to the head
installation conditions and environment.
• Do not install the head with the side surfaces or front surface facing upward. In addition, do not install the head inclined.
2-3-2 Carrying head part
WARNING
• To carry this product, wear the non-slip gloves and safety shoes. Hold the
product with both hands. Do not hold the cables or connectors at carrying.
• In case it falls down, it may cause injury.
ワㄐㄕㄊ㄄ㄆ
• Do not hold the fiber unit, cables and connectors at carrying this product.
• Do not touch the laser emission port on the bottom of the head. They may affect the laser processing quality badly.
• Carry the head as shown in the figure below.
Laser pointer
emission port
Fiber unit
Laser emission port
ME-VLW1N-SM-1