Panasonic VDR-M50GC, Инструкция по эксплуатации

Страница: 144 / 171

English
VQT0K98
145
Trouble Messages
A message may appear while you are operating the DVD Video Camera. If a message appears, refer to
the following table and take appropriate corrective action.
Message Cause & Troubleshooting
Reference
page
(1) Data error in a part of
image file. Repair data
now?
(2) Found error in image
file. Repair data now?
(3) Data error in all
image file. Repair all
data now? It is possible that the system cannot normally complete writing of file
when power is turned off for some reason during recording or
editing (deleting, dividing or combining scenes, or creating play list).
Selecting “YES” will automatically repair the video file, but even if
“NO” is selected, the same message will appear when the DVD
Video Camera is turned on next time. (Do not remove the disc while
the DVD Video Camera is recognising it: Ignoring this will deactivate
the file repair function.)
Follow the instructions on screen, taking note of the following
cautions:
•
Data may not be repaired, depending on the timing when power
was turned off.
•
Data may not be repaired normally if data recorded on another
recorder is mixed in.
•
The repaired data may be different from the original recorded
content because of partial deletion of defective portion.
•
Since the date/time for repair is added to the repaired data (only
the corrected portion for partial repair), the original date/time
information will be lost.
•
Since all movies, and then all stills, are repaired, the order of
recorded contents will be lost.
(In case of message (2) (3) only)
•
See *1 on page 152.

(1) Error has occurred.
Please restart. • Error has occurred. Try to restart the DVD Video Camera using
the following methods:
(1) Turn power off, remove the battery or AC adaptor/charger and
reattach it, and then turn power on again.
(2) Turn power off, and reinsert the disc. Then turn power on
again.
(3) See *3 on page 152.
(4) If you have another disc available, check to see if any problem
occurs with the disc. If another disc can be used normally, the
original disc may be defective: Contact the disc manufacturer.
If the above procedures cannot solve the problem, take note
of the error number, and contact your dealer.
Reference: “Error Code 2881” shows that the disc cannot be
recognized properly.
6, 40, 43, 44
(2) Error has occurred.
Please reinsert a disc.
(3) Error has occurred.
Error code No. xxxx.
Please read the manual.
(4) ERROR xxxx
313
ENG.book Page 145 Tuesday, March 23, 2004 8:12 PM