15
English
●
If there is a lead wire within approx. 3 mm from the
end face of the circuit board, the function board
cannot be attached due to interference with the guide
rail. Ensure that there is no lead wire in this range.
Approx. 3 mm
No lead wire in this range.
Circuit board
4
Remove the two screws from the main
unit slot cover.
Cover
Screw
5
Insert the function board to the main
unit slot, and tighten the two screws.
●
Tightening torque guideline: 1.4 N·m or less
Cautions when
moving
The display has handles for carrying. Hold them when
moving.
Handle
Note
●
Do not hold parts other than the handles.
●
4 or more people are required to carry this unit.
If this is not observed, the unit may drop, resulting in
injury.
●
When carrying the unit, keep the liquid crystal panel
upright.
Carrying the unit with the surface of the liquid crystal
panel facing up or down may cause deformation of
the panel, or internal damage.
●
Do not hold the upper, lower, right and left frames or
the corners of the unit. Do not hold the front surface
of the liquid crystal panel. Also, do not hit such parts.
Doing so may damage the liquid crystal panel.
Also, the panel may crack, resulting in injury.
