Panasonic SG-P Series, Инструкция по эксплуатации

Страница: 46 / 76

4.3.2 Teaching Setting
If pairing is required again when the actuator is replaced or for other reason, perform teaching
on the switch body ( SG-P20□-M-□ standard unit or SG-P20□-S sub unit ).
The following section describes the procedure for performing teaching on the SG-P20 □-M-□
standard unit and the actuator.
1.
Perform wiring and short circuit the check input (pink) of the SG-P20 □-M-□ with the +V
(brown).
2.
Turn ON the power supply and start teaching settings. At that time, make sure that the
actuator is in a non-detection state. When the teaching is started normally, the indicator is lit
in yellow. In four seconds after the power is turned ON, the SG-P20 □-M-□ transitions to the
teaching mode and the indicator blinks in yellow.
3.
Within six seconds after transitioning to the teaching mode, make the SG-P20□-M-□ detect
the actuator you want to teach. When the actuator is detected, the indicator is lit in green.
After the detection state is maintained for two seconds, the indicator blinks in green.
4.
Move the actuator away from the SG-P20□-M-□ and maintain a non-detection state. During
the non-detection state, the indicator is lit in yellow. After the non-detection state is
maintained for three seconds, the SG-P20□-M-□ transitions to the second teaching mode
and the indicator blinks in yellow.
4.3 Pairing (Only High-code Models)
4-6 WUME-SGPUM-2