17
Operating Instructions
If this unit is connected to a non-Panasonic
ARC compatible TV, connect using an optical
digital audio cable. (
>
10)
≥
After connecting the optical digital audio cable,
the setting of this unit must be changed to
specify the audio input terminal. (
>
right, “TV
Audio”)
Audio is output from the TV speakers and
not this unit’s.
≥
When connected to a VIERA Link (HDAVI
Control) compatible TV, change the audio
output settings to this unit. (
>
14)
Both main and secondary audio are output
simultaneously.
≥
Change the digital audio output setting on the
TV or connected device and then select the
desired audio channel. (For details, refer to
the operating instructions for the TV or
connected device.)
Refer to “Troubleshooting” (
>
16) before
changing any of the following settings.
The settings remain intact even if you switch the
unit to standby mode.
A
will blink green once when the setting is changed.
∫
VIERA Link
Changes to this setting become effective after
turning off and on all the connected devices.
Set “VIERA Link” to “Off”.
Set “VIERA Link” to “Off” when you do not want
to use “HDAVI Control”. (
>
16, “General
operation”)
Press and hold [INPUT SELECTOR] on this
unit and [BD/DVD] on the remote control for
more than 2 sec.
≥
When set to “Off”, the ARC function is not
available. Be sure to connect using the optical
digital audio cable. (
>
10)
Set “VIERA Link” to “On”.
Press and hold [INPUT SELECTOR] on this
unit and [SOUND EFFECT] on the remote
control for more than 2 sec.
∫
TV Audio
Set “TV Audio” to “ARC Off”.
Set “TV Audio” to “ARC Off” only when using an
optical digital audio cable with an ARC
compatible TV. (
>
16, “Sound”)
Press and hold [INPUT SELECTOR] on this
unit and [TV] on the remote control for more
than 2 sec.
Set “TV Audio” to “Auto”.
Press and hold [INPUT SELECTOR] on this
unit and [CLEAR-MODE DIALOG] on the
remote control for more than 2 sec.
When other Panasonic products respond to this
unit’s remote control, change the remote control
code on this unit and the remote control.
Preparation
≥
Turn off all other Panasonic products.
≥
Turn on this unit.
Change the remote control to code 2:
1
Aim the remote control at this unit’s remote
control sensor.
2
Press and hold [CLEAR-MODE DIALOG]
and [BD/DVD] on the remote control for
more than 4 sec.
A
will blink green once when the code of this
unit is changed.
≥
If the unit does not operate after changing the code,
repeat the steps
1
and
2
.
≥
To change the remote control to code 1, repeat the
steps above, but replace [BD/DVD] with [TV].
Changing this unit’s
settings
A
Remote control code
A
SCHTB10EB_RQTX1166-B.book Page 17 Thursday, June 10, 2010 3:06 PM
