18
With the IR Blaster connection, it is possible to send the IR signal received by this unit’s remote
control signal sensor to the TV’s sensor.
Use the TV’s remote control within this unit’s remote control signal
sensor’s operation range.
≥
For the operation range, refer to page 6.
1
Connect the jack plug to this unit’s Ir SYSTEM
terminal.
2
Place the infrared emitter in sight of the TV’s
remote control signal sensor.
≥
For the location of the TV’s remote control signal sensor,
refer to the operating instructions for the TV.
3
Aim the TV’s remote control at this unit’s remote
control sensor and operate the TV.
≥
For the location of this unit’s remote control signal sensor,
refer to page 6.
≥
Make sure to clean the surface, where the adhesive tape is
to be attached.
≥
If you peel off the adhesive tape, the surface may become damaged and exposed adhesive
may remain. Once you have confirmed the TV is operating correctly, secure it by attaching the
adhesive tape.
≥
The supplied IR Blaster is only compatible with Panasonic TVs.
∫
Placement example
On the rear of this unit:
Using the IR Blaster
Ir SYSTEM
A
Infrared emitter
TV remote control signal sensor
Adhesive tape
SCHTB10EB_RQTX1166-B.book Page 18 Thursday, June 10, 2010 3:06 PM
