22
22
RQTV0129
LANG - 5
LANG - 4
FRANÇAIS
DANSK
ENGLISH
Manual tuning
1
2
“
TUNED
” is displayed when a
radio station is tuned.
“
ST
” is displayed when a
stereo FM broadcast is being
received.
Select “FM” or “AM”.
The unit comes on.
Select the frequency.
Press and hold [
] or [
] until the frequency
starts scrolling to start automatic tuning. Tuning
stops when a station is found.
If noise is excessive in FM
Press [PLAY MODE] to display “MONO”.
Monaural sound is selected and noise reduces when
reception is weak.
Press [PLAY MODE] again to cancel the mode.
“MONO” is also canceled if the frequency is changed.
AM allocation setting
(main unit only)
This system can also receive AM broadcasts allocated in
10 kHz steps in addition to the 9 kHz steps.
To change the step from 9 kHz to 10 kHz
1
Select “FM”.
2
Press and hold [TUNER, BAND].
After a few seconds the display changes to a flashing
display of the current minimum frequency.
3
Continue to hold down [TUNER, BAND].
• When the minimum frequency changes, release
the button. To return to the original step, repeat the
above steps.
• After changing the setting, previously preset
frequency will be cleared.
Memory preset
(remote control only)
There are two methods of pre-setting stations.
Automatic presetting
: All the stations the tuner can receive are preset.
Manual presetting
: You can select the stations to preset and the order they are preset in.
Up to 15 stations each can be set in the FM and AM bands.
Preparation
Press [TUNER/MUSIC P.] to select “FM” or “AM”.
Automatic presetting
ENTER
Perform the following once each for
FM and AM.
Preparation
Tune to the frequency where pre-
setting is to begin.
• The tuner presets all the stations
it can receive into the channels in
ascending order. The last station to
be set is then played.
Press and
hold until the
frequency
changes.
Manual presetting
Pre-set the stations one at a time.
Tune to the
station
(
see
above).
ENTER
While “PGM” is flashing
on the display
The station occupying a channel is erased if another
station is preset in that channel.
Selecting a preset station
1
2
or
Select the channel.
• To select a 2-digit number
Example: 12: [ 10] [1] [2].
Select “FM” or “AM”.
The radio
RQTV0129-2G_1En.indd 22
2/9/06 4:26:09 PM
