Panasonic PV-M2738 Operating, Руководство по обслуживанию

Страница: 37 / 151

2-16
Locking Tab (K)
30 T Loading Arm Unit
31 S Loading
Arm Unit
Loading Rack Unit
Loading Rack Unit
Through Holes
Triangle Indent
T Loading Arm Unit S Loading Arm Unit
Arrow
Through Holes
32 Center
Clutch Unit
Mounting
Holes
33 Changing Gear
Spring
Cut Washer (B)
34 Changing Gear
36 Idler Arm
Unit
35 Changing
Lever -B
Mounting Pins
Center Clutch Unit, Changing Gear Spring,
Changing Gear, Changing Lever-B, and Idler
Arm Unit
Disassembly Procedure
1. Remove Cut Washer (B). Then remove the Center Clutch
Unit, Changing Gear Spring, and Changing Gear.
2. Remove Changing Lever -B so that the 2 Mounting Holes
clear Mounting Pins.
3. Pull up on the Idler Arm Unit.
Fig. J14-1
Reassembly Notes
1. Installation of Center Clutch Unit
1) Fit the Center Clutch Unit into the Changing Gear as
shown.
Fig. J14-2
2. Cut Washer (B) is not reusable. Install a new one.
Center Clutch Unit
Changing Gear
T Loading Arm Unit and S Loading Arm Unit
Disassembly Procedure
1. Remove the T Loading Arm Unit by pulling it up while
releasing Locking Tab (K).
2. Pull up on the S Loading Arm Unit.
Fig. J13-1
Reassembly Notes
1. Alignment of Loading Rack Unit, T Loading Arm Unit,
and S Loading Arm Unit
1) Slide the Loading Rack Unit so that the holes on it and
the holes on the chassis line up properly.
2) Install the S Loading Arm Unit onto the Chassis.
3) Install the T Loading Arm Unit so that the triangle-
shaped indent is aligned with the arrow on the S
Loading Arm Unit as shown. Confirm that each hole on
the T Loading Arm Unit, Chassis, and Loading Rack
Unit are through holes.
Fig. J13-2