f
The items will switch each time you press the button.
[NORMAL]
Select when high luminance is required.
[ECO]
Select when high luminance is not required.
Note
f
Set it to [ECO] rather than [NORMAL] when you want to reduce power consumption, extend the life of lamp and reduce
operation noise.
[ECO MANAGEMENT]
This function optimizes lamp power according to the operating status to reduce power consumption.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select the item.
Setting [AUTO POWER SAVE] in step 3)
Set whether or not to enable the three functions, [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTE
DETECTION].
4) Press
qw
to switch the [AUTO POWER SAVE].
[OFF]
Disables the energy conservation setting.
[ON]
Enables the energy conservation setting.
5) Press
as
to select one item.
[AMBIENT LIGHT DETECTION]
Adjusts the power of the lamp according to the brightness of the installation location.
[SIGNAL DETECTION]
Lowers the power of the lamp when there is no signal.
[AV MUTE DETECTION]
Lowers the power of the lamp when the [AV MUTE] is [ON].
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables above setting.
[ON]
Enables above setting.
Note
f
Lamp power cannot be reduced automatically in the following cases:
- When the lamp lit or the setting of [LAMP POWER] is completed, etc..
f
When [AUTO POWER SAVE] is set to [OFF], settings of [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], [AV
MUTE DETECTION] are unavailable.
f
When objects, etc. are placed around the luminance sensor on the top of the projector, [AMBIENT LIGHT DETECTION] may
not function properly.
Setting [POWER MANAGEMENT] in step 3)
Set the operation as following if there is no signal input.
1) Press
as
to select [POWER MANAGEMENT].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Power management function is off.
[READY]
The countdown timer is displayed after 30 seconds without input signal. The projection lamp turns off
and cools down when reaching the set time, meanwhile the projector is in the power management
mode. The projection lamp will be turned on if the input signal is reconnected or any button is pressed.
[SHUT DOWN]
The countdown timer is displayed after 30 seconds without input signal. The projection lamp is turned
off and cooled down when reached the set time, then the projector enter into standby status.
Setting [TIMER]
The timer can be set to 5-120 minutes. The increment is 5 minutes.
1) Press
as
to select [TIMER].
Chapter 4 Settings - [PROJECTOR SETUP] menu
72 -
ENGLISH
