Panasonic PT-JX200FBE, Инструкция по эксплуатации (Функциональное руководство)

Страница: 41 / 144

Chapter 3 Basic Operations — Turning on/off the projector
ENGLISH - 41
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.
1) Press
as
on the remote control to select the display language.
INITIAL SETTING
ENTER
SELECT
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
PORTUGUÊS
NEDERLANDS
SVENSKA
SUOMI
NORSK
Please select DISPLAY LANGUAGE.
SET
1/4
2) Press the <ENTER> button on the remote control to perform next initial setting.
Initial setting (installation setting)
Set [PROJECTION METHOD] and [VERTICAL FLIP] depending on the installation conditions. Refer to
“Installation form” (
x
page 29) for details.
Once the initial setting is completed, the settings for each item can be changed from the [SETUP] menu.
1) Press
as
on the remote control to select an item.
2) Press
qw
on the remote control to switch the setting.
2/4
◀
▶
INITIAL SETTING
PROJECTION METHOD
OFF
FRONT
VERTICAL FLIP
MENU SELECT CHANGE
SET
Change PROJECTION METHOD or VERTICAL FLIP
if the screen display is upside down or inverted.
ENTER
3) Press the <ENTER> button on the remote control to perform next initial setting.
Initial setting (standby mode)
Set the operation mode during the standby. The default setting is [ECO] that keeps power consumption low
during standby. If you use the network function during standby, set to [NORMAL]. If you want to keep the power
consumption low during standby, and to perform operation of power-on via wired LAN while the Wake on LAN
function is in use, set to [NETWORK]. Once the initial setting is completed, setting can be changed from the
[SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE].
1) Press
qw
on the remote control to switch the setting.
3/4
▶
Please set the power setting at standby mode.
Network function will be restricted
when it sets to ECO or Network.
INITIAL SETTING
STANDBY MODE ECO
CHANGE
SET
ENTER
◀
2) Press the <ENTER> button on the remote control to perform next initial setting.