Panasonic PanaVoice Courier, Руководство по установке

Страница: 20 / 141

PanaVoice Courier Installation Manual 19
5. Wire the DBS analog ports to the voice boards.
The order of the voice board connectors is clearly marked on the back of the PC
adjacent to each board.
IT IS IMPERATIVE THAT PORTS FROM THE DBS BE CONNECTED TO THE
VOICE BOARDS IN SEQUENTIAL ORDER.
YOU MUST MATCH THE LOWEST DBS PORT YOU ARE USING TO THE
LOWEST VOICE BOARD PORT AND CONTINUE IN SEQUENTIAL ORDER.
For example, if you are using ports 9,10,11 and 12 of the DBS, port 9 should be
connected to Port 1 of the voice board, port 10 to port 2 of the voice board and so on.
The Courier and Courier Plus Systems use 2- and 4-port ISA voice boards depending on
the configuration. The 2-port voice boards have two connectors handling 1 port each and
are clearly designated on the back of the PC adjacent to the voice board. In the case of
a 2-port voice board, the center pair of the connector must be connected to the DBS
analog port. Refer to diagram C001 for the pin configuration of these connectors.
In the case of a 4-port voice board, there are also 2 connectors on the voice board.
These will also be clearly marked on the PC. In this case, the center pair of each
connector is the first port of that connector and the outer pair is the second. Since the
Courier Plus system uses the same connector types, you can refer to diagram C002 for
the pin configuration.
The Courier UMS uses both 4- and 8-port PCI voice boards depending on the
configuration. The Pin configuration is the same as the Courier and Courier plus units in
that the center pair of the first connector is port 1; the outer pair is port 2 and so on for
each connector. For an example of the pin configuration of a 4-port Courier UMS, refer
to diagram C003.