PAN301x Bluetooth Module
6 Regulatory and Certification Information
Module Integration Guide Rev. 1.0
Page 22 of 30
6.2.6
RF Exposure
To comply with FCC RF Exposure requirements, the OEM must ensure that
only antennas from the Approved Antenna List are installed
The preceding statement must be included as a
“CAUTION” statement in
manuals for products operating with the approved antennas in the previous
table to alert users on FCC RF Exposure compliance.
Any notification to the end user of installation or removal instructions about the
integrated radio module is not allowed.
The radiated output power of the PAN3011, PAN3012, and PAN3013 with a
mounted ceramic antenna (
FCC ID: T7V301X
) is below the FCC radio
frequency exposure limits. Nevertheless, the PAN3011, PAN3012, and
PAN3013 shall be used in such a manner that the potential for human contact
during normal operation is minimized.
End users may not be provided with the module installation instructions.
OEM integrators and end users must be provided with transmitter operating
conditions for satisfying RF exposure compliance.
6.2.7
Integration Instructions
This chapter gives integration instructions for host product manufacturers according to KDB
“996369 D03 OEM Manual v01”.
Section Topic and Comment
2.2
List of applicable FCC rules
47 CFR Section
Part 15C
Frequency Band (MHz)
2 400 to 2 483.5
Systems
Digital Transmission Systems operating within the 2 400
MHz to
2 483.5
MHz Band
Reference / Requirement
15.247
Complied Module M/N
ENW89855A1KF, ENW89855A2KF, ENW89855A3KF
2.3
Summarize the specific operational use conditions
Please refer to
, and
2.4 Limited module procedures
Not applicable, the module has a single-modular transmitter approval.
2.5 Trace antenna designs
Not applicable, the module has a ceramic chip antenna. For guidance regarding the PCB
layout requirements for module integration refer to
