Before Use
-16-
Selecting Remote Controller Modes
When 2 Camcorders are used simultaneously,
they can be operated individually by selecting
different Remote Controller Modes.
≥
If the Remote Controller Mode of the
Camcorder and that of the Remote Controller
do not match, [REMOTE] Indication is
displayed.
Setup on the Camcorder:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (
-23-
)
Setup on the Remote Controller:
[VCR1]: Press the [
D
] Button and [
∫
] Button
simultaneously.
1
[VCR2]: Press the [
E
] Button and [
∫
] Button
simultaneously.
2
≥
When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
Power Supply
ª
Using the AC Adaptor
1
Connect the DC Cable to the Camcorder.
2
Connect the DC Cable to the AC Adaptor.
3
Connect the AC Cable to the AC Adaptor
and the AC Jack.
≥
The AC Cable’s outlet plug does not fit
entirely into the AC Adaptor jack. A gap will
remain as shown
1
.
≥
Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Camcorder to [OFF] and make sure that
[POWER] Lamp is not lit.
INDEX
INDEX
SELECT
STOP
K
L
∫
STILL ADV
T
W
PAUSE STILL ADV
6
1
5
;
E
D
P.B. ZOOM
2
1
1
ª
Using the Battery
Before use, fully charge the Battery.
≥
We recommend using a Panasonic Battery.
≥
We cannot guarantee the quality of this
Camcorder when batteries from other
companies are used.
1
Attach the Battery to the AC Adaptor and
charge it.
≥
Since the Battery will not be charged when
the DC Cable is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥
The [CHARGE] Lamp lights up, and charging
starts.
≥
When the [CHARGE] Lamp goes off,
charging is completed.
≥
When the battery is completely discharged,
the [CHARGE] lamp blinks at first, but the
battery is charged normally. When the
temperature of the battery is too high or low,
the [CHARGE] lamp blinks and the charging
time becomes longer than usual.
2
Attach the charged Battery to the
Camcorder.
Disconnecting the Power Source
Set the [OFF/ON] Switch
(43)
to [OFF] and, while
pressing the [PUSH BATT] Button
(50)
, slide the
Battery or DC Cable upward to disconnect it.
≥
For other notes concerning this item, see
-71-
.
PUSH
BATT
ON
OFF
(50)
(43)
PV-GS120_200Eng.book 16 ページ ２００４年２月１６日 月曜日 午後１時３２分
