Panasonic NV-FJ762EE, Руководство по эксплуатации

Страница: 40 / 61

40
2
1
Connecting the VCR to a Satellite Receiver or Digital
Receiver
Satellite receiver here includes a digital receiver.
The connection method differs depending on the type of your
satellite receiver.
For details about the connection, also read the satellite
receiver’s operating instructions.
If the Satellite Receiver is Equipped with a
21-pin Scart Socket
If your satellite receiver is equipped with a 21-pin Scart
socket, use a 21-pin Scart cable to connect the VCR.
For the connection to the TV, refer to pages 10 and 12.
Be sure to keep the VCR, TV and satellite receiver switched
off until you have finished all connections.
For your safety, do not connect or handle the equipment with
wet hands.
To an AC Mains socket
21-pin Scart cable
(not supplied)
1 Connect a 21-pin Scart cable (not supplied) to the AV2
21-pin Scart socket
l
on the VCR and to the 21-pin
Scart socket on the satellite receiver.
2 Connect the satellite receiver’s mains lead to an AC
mains socket.
3 Set “AV2” to “EXT”.
For details, see page 52.
Satellite receiver (not supplied)
21-pin Scart socket
¡
If your satellite
receiver has a
VCR socket,
connect the cable
to it.
If the Satellite Receiver Is Not Equipped
with a 21-Pin Scart Socket
In case your satellite receiver is not equipped with a 21-pin
Scart socket, use the RF coaxial cable to connect it to the
VCR.
For the connection to the TV, refer to pages 10 and 12.
Be sure to keep the VCR, TV and satellite receiver switched
off until you have finished all connections.
For your safety, do not connect or handle the equipment with
wet hands.
1 Connect the aerial lead to the Aerial Input socket on the
satellite receiver.
2 Connect the RF coaxial cable to the Aerial Output socket
on the satellite receiver and to the Aerial Input socket
n
on the VCR.
3 Connect the satellite receiver’s mains lead to an AC
mains socket.
Hint:
¡ The RF output channel of the satellite receiver should be
adjusted away from channel 38, which is used by the VCR,
e.g. re-adjust to channel 33.
Note:
How to install the satellite receiver
Carefully observe the following points so that you can control
the satellite receiver from the VCR.
1 Place the satellite receiver on top of the VCR.
2 Move the satellite receiver back a few centimetres so that
infra-red signals emitted from the top of the VCR’s front
panel can be received by the satellite receiver.
1
2
3
Aerial (not supplied)
Satellite receiver (not supplied)
Aerial Input socket
Aerial lead
(not supplied)
To an AC mains socket
Aerial Output
socket
RF coaxial cable
(not supplied)
l
n
Satellite receiver
21-pin Scart cable
or RF coaxial cable
Infra-red signal
transmitter
[
VCR