Panasonic KX-TVS50 - 2 Port Voicemail System, Руководство по установке

Страница: 145 / 416

CUSTOMIZING THE SYSTEM
Installation Manual 145
Enter the data using the following table as a guide.
Table 26
Parameter Value Range
(Default)
Description/Function
Dial Number Up to 32 digits
consisting of 1-9,
0, , #
P, T, M, X
(None)
Assigns a telephone or beeper number to Device 1, 2, or
3. The subscriber can also specify the dial number from
his telephone.
P: Pause
T: Dial Tone Detection
M: Dial Mode Switching Code (Touchtone to Pulse, or
Pulse to Touchtone)
X: Callback Number Entry Code
1-9, 0, , #: Dial Codes
Note: The callback number entry code "X" must be
included in the number to be called if the Beeper
Callback No. Entry Mode is enabled through COS and
"Type of Device" is set to "Beeper". The proper number
of "Pauses" must be inserted before the callback entry
code.
Important Note: When the VPS calls to a CO line via
the KX-TD500 PRI Card (KX-TD50290: PRI23 [ISDN
Primary Rate Access Interface card]), be sure to add "#"
after the telephone number (1112223333 in the
example here):
Example: 9P1112223333#PP123PP456PPX#
Type of Device 1. Telephone
2. Beeper
(Telephone)
Specifies the device to receive notification. This is
automatically set to "Beeper" when "X" is used in the
Dial Number (above). The subscriber can also specify
the type of device from his telephone.
Use Mode 1. Not Use
2. Continuously
3. Scheduled
(Continuously)
Specifies how Device 1, 2, or 3 is to be used. The
subscriber can also specify the use mode from his
telephone.
1. Not Use—Device 1, 2, or 3 is not used for a
notification call.
2. Continuously—Device 1, 2, or 3 is called whenever
a message is recorded in the mailbox.
3. Scheduled—Device 1, 2, or 3 is called on a schedule
basis when a message has been left in the mailbox.