Panasonic KX-TVS50 - 2 Port Voicemail System, Руководство по установке

Страница: 283 / 416

SYSTEM ADMINISTRATOR'S GUIDE
Installation Manual 283
Message
Waiting Lamp
Ports Port No.
(1-2)
Specifies the port numbers used for the Message Waiting
Notification Lamp feature.
The VPS turns on the Message Waiting Lamp of the
extension using the port specified in this parameter. At
least 1 port must be specified.
Message
Waiting Lamp
for Every
Message 1. No
2. Yes
(Yes)
If set to "Yes", the VPS will turn on the Message Waiting
Lamp of the extension each time a new message is
recorded in the mailbox. This will occur even if the
Message Waiting Lamp was not turned off from a
previous message. This setting is useful when the first
attempt is unsuccessful.
If set to "No", the VPS will turn on the Message Waiting
Lamp for the first message only. The VPS will not turn on
the lamp for subsequent messages until the subscriber has
accessed the VPS to retrieve the messages stored there.
Max. Digits for
Callback No. 1-48 digits
(20)
Specifies the maximum number of digits the caller can
enter as a callback number. This number will display on
beepers if the "Beeper Callback No. Entry Mode" is
enabled.
Callback No.
Entry Interdigit
Time-Out 1-10 s
(5)
Sets the maximum allowable time between each digit on
Beeper Callback No. Entry. If the caller does not enter
any digits within the specified time, the VPS will not
accept entry of any additional digits.
System
Callback No. Up to 32 digits
(None)
Specifies a telephone number that will display on the
subscriber's beeper as a callback number. The callback
number entry mode "X" must be included in the
telephone number.
Note: If "Beeper Callback No. Entry Mode" is enabled
through COS, the callback number entered by the caller
will display on the destination beeper. However, if the
caller fails to enter a callback number, the System
Callback No. will display instead.
Table 63
Parameter Value Range
(Default)
Description/Function