Settings and Printing
Maintenance
Specifications
17
Power Saver
To conserve energy and operating cost, this printer is provided with a programmable power save
feature. The printer is factory set with the power save feature turned on to comply with E
NERGY
S
TAR
®
requirement. If power saver is enabled, the printer enters the Power Saver mode when the printer is
idle for 30 minutes.
If the power save feature is turned off, the temperature of the fuser unit in the printer is decreased to
save the power consumption when the printer is idle for 1 hour.
Network Protocol Setup
Selects DHCP or sets the addresses used by the TCP/IP protocol.
■
DHCP
DHCP automatically requests an IP address for the printer from a DHCP server.
■
Ethernet IP Address/Ethernet Subnet Mask/Gateway Address
If the DHCP is enabled, these menus will not appear. During setting, use the
G
/CANCEL,
F
/CONTINUE and
H
/ENTER buttons.
G
/CANCEL button:
decreases the numerical value
F
/CONTINUE button: increases the numerical value
H
/ENTER button:
moves the cursor to right
Adjustment to Media
If the print quality deteriorates when you print on other than recommended media (see
Specifications
),
the print quality may be improved by changing the setting of Adjustment to Media. The settings you
have changed will remain effective even if the power is turned off. Reset the settings again if any
changes in media or deterioration in print quality occurs. To reset the settings, refer to
Setting the
"
Adjustment to Media”
for instructions
.
■
Plain Paper / Transparency / Label / Coated Paper / Envelope / Card
It enables you to change the setting of the selected media in the menu.
You can select a value from 11 different levels (-5 to 5).
Language
Specifies the language of the LCD text and the language used in the Configuration Page.
Using the Printer Panel (Menu Mode)