Panasonic KX-HGW600, Руководство по эксплуатации

Страница: 142 / 152

Operating Instructions
142
About Network Camera Setup
Problem Cause and Remedy
The Automatic Setup function
does not work. • Make sure the connection between the device and
the KX-HGW600 have been successfully made.
• The Automatic Setup function is only available for
20 minutes after the Network Camera is turned on.
Restart the Network Camera.
• Make sure Enable is checked on the Network
window of Network Camera ( [Network] 1.
Network Configuration from the Setup
Program
).
• If you connect the KX-HGW600 to the wireless
devices, make sure the wireless devices are not
connected to the other wireless routers. In this case,
turn off the other routers and restart the Network
Camera. Then, set the same SSID to the
KX-HGW600 and the Network Camera.
• The IP addresses " 192.168.0.113 - 192.168.0.128 "
are used for the Automatic Setup function. If the
other devices use the corresponding IP addresses,
change the other IP addresses.
The authentication window
appears when you access the
Camera Portal page. • Administrator Only is checked on the Access
Control window. Enter the registered user name and
password.
• If the authentication of the Network Camera is set
Administrator and General User on the Security:
Administrator window, please change the setting to
Administrator Only .
The automatically set up
Network Camera is removed
from the Camera Portal page. • If you check Do Not Use on the Setup Page of the
KX-HGW600 ( [Optional Setup] DHCP ), set up
the Network Camera manually.
You cannot set up the
Network Camera manually. • The IP addresses " 192.168.0.113 - 192.168.0.128 "
and the port numbers " 60001 - 60016 " are used for
the Automatic Setup function. If you use the
corresponding IP addresses or port numbers,
change to the other IP addresses or port numbers.