2. Preparation
17
2.3.2 Using the auto document feeder
1
Insert the document (up to 40 pages) FACE UP into
the feeder until a single beep is heard.
2
Adjust the width of the document guides (
1
) to fit
the actual size of the document.
Note:
L
Confirm that there are no documents on the scanner
glass.
L
Check that ink, paste or correction fluid has dried
completely.
L
Remove clips, staples or other fasteners.
L
Do not set the following types of documents: (Make a
copy of the document using the scanner glass and
set the copy instead.)
–
Chemically treated paper such as carbon or
carbonless duplicating paper
–
Electrostatically charged paper
–
Badly curled, creased or torn paper
–
Paper with a coated surface
–
Paper with printing on the opposite side that can
be seen through the other side, such as
newsprint
L
The total height of the documents when laid flat,
must be less than 4 mm. If the documents exceed the
capacity of the auto document feeder, they may fall or
cause a jam in the feeder.
L
To set a document with a width of less than 210 mm,
we recommend using the scanner glass to copy the
original document onto A4 or letter-sized paper, then
setting the copied document.
L
Do not set documents that do not satisfy the
requirements of size and weight. Make a copy of the
document using the scanner glass and set the copy.
L
Available document size, document weight and
effective scanning area are as follows:
Minimum document size
Maximum document size
Effective scanning area
L
Shaded area will be scanned.
Document weight
L
Single sheet:
45 g/m
2
to 90 g/m
2
L
Multiple sheets:
60 g/m
2
to 80 g/m
2
1
128 mm
128 mm
600 mm
216 mm
216 mm
208 mm
4 mm
4 mm
4 mm
4 mm
FLB881E-PFQX2796ZA-OI-en.book Page 17 Thursday, September 13, 2007 2:16 PM
Содержание KX-FLB881E
Страница 103: ...103 Notes ...
Страница 104: ...PFQX2796ZA CM0907CJ0 CD ...