Installation/Registering the Repeater
Once the repeater is connected to an AC outlet, it automatically goes into registration mode (if not
already registered).
IMPORTANT
R
Before registering the repeater to the base unit, you must turn the repeater mode on. Refer to the
appropriate documentation for the base unit.
R
If the repeater is already registered, deregister the repeater first, then re-register it. For registering and
deregistering the repeater, refer to "Deregister" and "Re-register" in "Troubleshooting".
Note
R
Use only the supplied Panasonic AC adaptor.
R
When connecting the AC adaptor to the repeater, press the plug firmly into the repeater for secure
connection.
1
Repeater: Connect the AC adaptor.
2
Base unit: Press and hold the Handset locator button for about 4 seconds until the STATUS
indicator flashes red.
R
The button and indicator depend on the base unit.
R
If all registered handsets start ringing, press the same button to stop. Then repeat this step.
R
The next step must be completed within 90 seconds.
3
Repeater: Connect the AC adaptor to an AC outlet.
R
When the repeater is turned on, the STATUS indicator and RSSI/ID indicator turn amber for about
2 seconds.
4
Repeater: Wait until the STATUS indicator and RSSI/ID indicator turn green. (The repeater is
ready for use.)
R
If the indicators do not turn green, re-position the repeater in a place where the indicators turn
green.
5
Base unit: To exit registration mode, press the Handset locator button.
R
The button depends on the base unit.
23
2. Linking to SIP Cordless Phones
