Problem
Cause/solution
A repeating tone is heard while talking
using the handset.
or
The STATUS indicator is amber and
the RSSI/ID indicator flashes green.
R
The PROGRAM button was pressed. The repeater is in
programming mode. To exit, press the PROGRAM button
again. Do not press the PROGRAM button, except when
deregistering the repeater.
The repeater’s STATUS indicator and
RSSI/ID indicator flash green and red
alternately (alarm indication).
R
The ID of the repeater is the same as the ID of another
repeater that is registered to the same base unit.
Deregister both of the repeaters, then re-register them near
the base unit.
Deregister
1
Unplug the AC adaptor, then press and hold the
PROGRAM button.
2
While pressing and holding the PROGRAM button,
re-connect the AC adaptor.
3
Keep pressing and holding the PROGRAM button for
about 10 seconds until the STATUS indicator stops
flashing and RSSI/ID indicator turns red. Then release
the PROGRAM button.
R
The STATUS indicator and the RSSI/ID indicator turn
amber for about 2 seconds and the STATUS indicator
flashes red again.
R
If the STATUS indicator flashes green after releasing the
PROGRAM button, deregistration failed. Deregister the
repeater again.
Re-register
Unplug the AC adaptor, then perform from step 2 of
“Installation/Registering the Repeater”.
The handset registered to the repeater
cannot make/receive a call.
R
When the STATUS indicator flashes green rapidly, a
handset registered to the repeater cannot make/receive a
call through the repeater. Move closer to the base unit or
wait until the STATUS indicator flashes slowly or the
STATUS indicator is on.
25
2. Linking to SIP Cordless Phones
