24
Rev.1.1
IMPORTANT:
•
Procure 4 screws (M4) to secure the receiver attachment (accessory) to a ceiling or a wall
according to the material of the installation area. In this case, wood screws and nails should not
be used. For mounting a receiver on a concrete wall, use an anchor bolt (M4) or an AY plug bolt
(M4) for securing. (Recommended tightening torque: 1.6 N
・
m {1.18 lbf
・
ft})
•
Mount the receiver attachment (accessory) in consideration of the camera angle in accordance
with the instructions
•
Required pull-out capacity of a single screw/bolt is 196 N {44 lbf} or more.
•
If a ceiling board such as plaster board is too weak to support the total weight, the area shall
be sufficiently reinforced.
•
Install the receiver mount bracket (locally procured) in the foundation area of the architecture or
where sufficient strength is assured.
•
To prevent the mounting strength from becoming lower, do not use wooden screws to secure
the receiver mount bracket (locally procured).
Installation place Applicable mount bracket Recommended screw Number of screw Minimum pull-out strength (per 1 pc.)
Wall Mounting plate (Accessory) M4 4 pcs. 196 N {44 lbf}