22
FURTHER INFORMATION
nanoe
®
5
35
2
30
%
85
%
nanoe
®
Room temperature: about 5
35
(dew-point temperature: 2
)
Conditions for nanoe
®
generation
Relative humidity: about 30% 85%
nanoe
®
is generated by using the air in the room. Therefore, due to the differences in temperature
and humidity nanoe
®
may not be generated stably.
When nanoe
®
is generated, small amount of ozone will be released. However, the quantity will be
far less than the level in natural environment such as forest, and not be harmful to human beings.
nanoe
®
About nanoe
®
During operation, press
and
buttons at the same time for about 3 seconds
nanoe
®
indicator lights off) Press the buttons for about 3 seconds again to restart the nanoe
®
.
(nanoe
®
cannot be set during product stops operating.)
nanoe
®
can be switched off. nanoe
®
3
nanoe
®
3
nanoe
®
nanoe
®
150
°
2.5 m
25
“
3
PM2.5
/
15
°
°
Normal sensitivity
High sensitivity
Sensible range:
The sensing distance
is about 2.5 m
The sensing angle is
about 150°
At a room temperature
of 25 :
Detection image (when detecting the front
of this product)
No human
activity sensing
The sensor sensitivity is adjustable. (The factory setting is “normal sensitivity”.)
When the product stops operating, press and hold for about 3 seconds. At this moment, all the
control buttons and the filter replacement indicator light on, and the air volume indicator flashes.
Under such condition, each time you press , the PM2.5 concentration/timer display window will
switch once in the order as shown in the following figure. The setting will be automatically saved
within about 15 seconds after the selection is completed. Now the setting is completed.
When the movement of a person or pet is detected, the air volume is automatically adjusted. When
the generation of indoor dust is predicted, the product starts operating before the indoor air pollution
spreads. (When the air volume is set to auto.) (Not all pet movements can be detected.)
About human sensor
