Panasonic ET-YFB200G, Руководство по эксплуатации

Страница: 39 / 97

Chapter 4 Settings — Menu navigation
ENGLISH - 39
f
When 3D signal is output from the device, the menu of the device is not displayed. To change the setting of the device, input the 2D signal
or operate without inputting any signal.
f
When 3D signal is output from the device, all the setting items in the [PICTURE] menu and the [POSITION] menu are disabled.
f
The cursor color depends on the setting in the [OPTION] menu → [ON-SCREEN SETTING] → [OSD DESIGN]. The selected item is
displayed with the yellow cursor by default.
f
When the [OPTION] menu → [ON-SCREEN SETTING] → [OSD OUTPUT] is set to [DVI-D/DIGITAL LINK], the menu screen (OSD) is
not displayed on any image display device screen connected to the <DVI-D OUT> terminal or the <DIGITAL LINK OUT 2> terminal if the
connection status is as follows. Operate after turning on the power of the image display device connected to the <DIGITAL LINK OUT 1>
terminal.
g
Displays (projector or flat panel display) are connected to both the <DIGITAL LINK OUT 1> terminal and the <DIGITAL LINK OUT 2>
terminal.
g
Display connected to the <DIGITAL LINK OUT 1> terminal is in standby mode.
If the display connected to the <DIGITAL LINK OUT 1> terminal cannot be turned on due to defect, etc., press and hold the <MENU>
button on the control panel of this device for 3 seconds or longer. The menu screen is forcefully output to the output image of all the output
terminal.
Resetting adjusted values to the factory default
If there is the DEFAULT button on the remote control, the values set and adjusted in the menu item will return to
the factory setting when this button is pressed.
1) Press the DEFAULT button on the remote control.
f
The operation varies depending on the displayed screen.
g
When the sub-menu screen is displayed
The displayed sub-menu items are restored to the factory default settings.
g
When the individual adjustment screen is displayed
Only items during adjustment are restored to the factory default settings.
+24 CLAMP POSITION
Note
f
The DEFAULT button may not be present on the remote control depending on the display (projector or flat panel display) in use.
f
Returning all the values set and adjusted in the menu item is performed with [OPTION] menu → [INITIALIZE] (
x
page 62).
f
The mark above the bar scale in the individual adjustment screen indicates the factory default setting. The position of this mark varies
depending on the selected input signals.
+
10
Factory setting
Current adjustment value
Main menu
The following items are in the main menu.
When a main menu item is selected, the screen changes to a sub-menu selection screen.
Main menu item Page
[INPUT SELECT] 39
[PICTURE] 40
[POSITION] 40
[LANGUAGE] 40
[OPTION] 40
Sub-menu
The sub-menu of the selected main menu item is displayed, and you can set and adjust items in the sub-menu.
[INPUT SELECT]
Details (
x
page 41)