- 5 -
HOW TO USE ELECTRIC HOME SHOWER
1. HOW TO USE
Do not block the Shower Head with hand, towel
or bend the Shower Hose. The water flow rate will
drop and water temperature may become very hot.
CAUTION
1. Turn the Water Volume Knob clockwise to turn on the water (make sure the Main Water Valve is on).
(Water will flow out from Shower Head at inlet water temperature).
2. Switch on the Miniature Circuit Breaker (MCB) and ON/OFF DP (double pole) Switch.
3. Push up the ELB Reset Lever if it is down.
4. Turn the Main Switch Knob to "On" (ELB Lamp will light).
5. The shower temperature can be gradually controlled by turning the Power Control Knob.
If the Power Control Knob is turned clockwise, the shower temperature will increase, reaching the highest
temperature at 'High'.
• If the Water Volume Knob is turned clockwise, the volume of water will increase thus the water
temperature will decrease.
• If the Water Volume Knob is turned anticlockwise, the volume of water will decrease thus the water
temperature will increase. (Please refer WATER FLOW RATE ADJUSTMENT below).
6. After using this Unit, please turn off the Main Switch Knob and turn off the water supply by turning the
Water Volume Knob anticlockwise until water flow is completely stop.
(1) Maximum water flow rate can be adjusted by using Main Water Valve.
Step 1: Turn "OFF" the Main Water Valve.
Step 2: Turn the Shower Head upward at waist height.
Step 3: Turn the Water Volume Knob clockwise to maximum volume position.
Step 4: Gradually turn "ON" the Main Water Valve and adjust the splashing height (H) of the shower.
It is recommended to adjust the water splashing height (H) at 100 cm - 110 cm (approximately 3 L/min).
Note: 1. After setting maximum flow rate, please use Water Volume Knob to turn on and turn off the water supply.
2. Pay attention to shower temperature when reducing the volume of water.
The shower temperature will become very hot if the water flow rate is too low.
3. In case of continuous usage at high temperature setting, water temperature will increase and the control device
will activate temporary resulting the water temperature to drop.
Floor
Water Volume
Knob
Main Water
Valve
H = 100 cm - 110 cm
Waist Height
2. WATER FLOW RATE ADJUSTMENT
Note: In case of no water supply, close the Water Volume Knob by turning it anticlockwise and make
sure the Main Switch Knob and the Power Control Knob are in "Off" condition (ELB light is off).
This is to prevent unnecessary water flow from Shower Head after the water supply recovered.
ELB: On condition
ELB: Off condition
ELB Test
ELB Reset
Push Up
Po
wer Control
Mai
n Switch
ELB
Off
Off
High
On
ELB Test
ELB Reset
Push Up
Po
wer Control
Mai
n Switch
ELB
Off
Off
High
On
O
PE
N
CL
O
SE
FILTER
CLEANING
OFF
MAX
ELB Test
ELB Reset
Push Up
Pow
er Control
Mai
n Switch
ELB
Off
Off
High
On
BEFORE USING
