Panasonic DBS 96, Руководство пользователя

Страница: 44 / 159

Chapter 3. Cabinet Installation Section
Test Phone
Guidelines
l
The test terminal (CN3) on the DBS Connector Panel can be used to
connect a display phone for programming.
The test terminal can be used for initial programming before extension
cabling is completed.
l
The test terminal is turned on by flipping SW1 on the Connector Panel to
the “Test” position. When SW 1 is in the test position, extension ports 7 and
8 are connected through the test terminal. When SW1 is not in the test
position, extension ports 7 and 8 are connected through the
Note: Before using the test terminal on a DBS that is operational, be sure
the phones connected to ports 7 and 8 can be taken out of service.
l
A can be connected to the display phone for text entry. Port 7 must
be assigned as extension 101 and the must be assigned as
telephone type 13 for the to operate.
Installation
1. Connect the telephone and DSS (optional) to CN3 on the Connector
Panel. (See on page 19.)
2. Set SW 1 to “Test.”
3. When programming is completed, set SW 1 back to “ST.”
3-1 Manual Issued