Panasonic DBS 96, Руководство пользователя

Страница: 72 / 159

Section
Chapter 4. Trunks and Lines
Installing in a Double Cabinet with the in the Slave
1.
2.
3.
4.
5.
6.
7.
8.
Install the Sync Unit in the master cabinet as described in Steps 1 and 2
under “Installation for a Single
Install a MDF card in the slave cabinet. (See Step 3 on page 4-23.)
Set Switch 1 on the card. (See Step 4 on page 4-24.)
Install a card in the slot of the slave cabinet.
Connect the Sync Cable from on the Sync Unit to on the
card (Figure 4-l 1).
Note:
Part Number VB-43564 is used for the Sync Cable when a is
installed only in the slave cabinet of two-cabinet system.
At the slave cabinet, connect the cable attached to CN3 on the MDF
card to CN3 on the card (Figure 4-10).
Using an RJ48 cable, connect of the MDF card to the CSU. (See
Figure 4-9 on page 4-25 for RJ48 pinouts.)
At the slave cabinet, connect the ground cable on the MDF card as
shown in Figure 4-10 on page 4-26.
DBS Manual Issued
4-27