Panasonic CS-VE9NKE, Руководство по обслуживанию

Страница: 43 / 140

43
12.10 nanoe-G Operation

This operation provides clean air by producing great amount of negative ions and distribute through the
discharge airflow to capture or deactivate molds, bacteria or viruses.

nanoe-G ON/OFF condition
Priority Item Output
“No NANOE-G” is selected during model selection.
During Demo mode
Two-way communications on remote control
NANOE-G connector open
1
NANOE-G error (circuit error & abnormal discharge detection)
OFF
Inspection mode NANOE-G ON command ON
2
Inspection mode NANOE-G OFF command OFF
No “NANOE-G” setting on the remote control
Operation status: OFF
During NANOE-G restart prohibiting time
(Prohibiting time is set in the case of abnormal discharge and room temperature of 40°C
and above. Details will be provided later.)
3
During FM OFF; or FM rotation speed is less than 490 rpm
OFF
Less than 60 minutes have elapsed
since the start of Powerful
individual fan operation.
ON
Ordinary vertical louver selected; or Airflow
direction is not set to ceiling airflow or DOWN

Other than above
4
Twin louver is selected; or airflow direction is ceiling airflow or DOWN

ON/OFF
intermittent output
as mentioned
below

ON/OFF intermittent output

nanoe-G operation pause condition
o
When indoor fan stop (during deice, odor cut control, thermostat off, etc.). nanoe-G operation resume after
indoor fan restarts.
o
When indoor intake temperature ≥ 40°C. nanoe-G operation resume after indoor intake temperature ≤ 40°C
continuously for 30 minutes.

Indoor fan control
o
During any operation mode combines with nanoe-G operation, fan speed follows respective operation mode.
However, nanoe-G system enabled when fan speed ≥ 490 rpm to ensure proper negative ion distribution,
nanoe-G system disabled when fan speed < 490 rpm.

Airflow direction control
o
During any operation mode combines with nanoe-G operation, airflow direction follows respective operation
mode.
o
During nanoe-G individual operation, only Auto Air Swing is allowed. Even if Air Swing button is pressed, no
signal is sent to the unit and no change on remote control display.

Timer control
o
When ON Timer activates when unit stops, previous operation resumes and restored last saved nanoe-G
operation status.
o
When ON Timer activates during any operation, no change on current operation.
o
When OFF Timer activates during any operation, all operation stops and the latest nanoe-G operation status
is saved.

Indicator
o
When nanoe-G starts, nanoe-G indicator ON.