Panasonic CS-ME12NKE, Техническое и сервисное руководство

Страница: 315 / 440

1HR.
T I MER
ON/OFF
operation
ACL
(Reset)
QU I ET
button
button
button
button
6. Address Switch
6-1. Address Setting of the Remote Controller
The address can be set in order to prevent interference between remote con-
trollers when 2 indoor units are installed near each other. The address is nor-
mally set to “A.” To set a different address, it is necessary to change the
address on the second remote controller.
Once changed, you cannot restore the original address setting of the air con-
ditioner.
(1) Switch on the power source.
(2) Break the address-setting tab marked “A” on the second remote controller
to change the address (Fig. 62). When the tab is removed, the address is
automatically set to B (Fig. 63).
(3) Press and hold the remote controller QUIET button and 1HR. TIMER but-
WRQ7KHQSUHVVDQGKROGWKH$&/5HVHWEXWWRQZLWKDSRLQWHGREMHFW
VXFKDVWKHWLSRIDSHQ$IWHUVHFRQGVUHOHDVHWKH$&/EXWWRQILUVW
then release the QUIET and 1HR. TIMER buttons. “oP-1” (Test Run)
appears, blinking in the remote controller clock display area.
NOTE
English
(4) Each time the 1HR. TIMER button is pressed,
the display changes as shown below.
Press this button 2 times to change the
display to “oP-7” (Address setting).
(Fig. 64)
(5) “oP-7” has now been selected for address
setting.
(6) Press the ON/OFF operation button on the
remote controller. (Fig. 64) Check that the
“beep”signal-received sound is heard from the
second indoor unit (approximately 5 times).
The sound you hear is the signal that the
remote controller address has been changed.
)LQDOO\SUHVVWKHUHPRWHFRQWUROOHU$&/5HVHW
button to cancel the blinking “oP-7” display.
(Fig. 64)
Changing of the second remote controller address
is now completed.
Selfdiagnostic mode
Test run mode
Address setting mode
Fig. 62
Fig. 63
Tab
ACL button
Fig. 64
19
12-295 CU-5E34NBE_IU EN_3.qxd 2/27/12 4:35 PM Page 19