Panasonic AW-RP50, Быстрый старт

Страница: 1 / 14

1.
Connect AW-RP50 LAN port and
AW-XXXX
LAN port using a LAN cable. (
AW-XXXX
can
automatically recognize whether it is a cross or straight cable.)
* LAN Cable: Category 5 or higher, Up to 100m (Category 5e or higher if connected via a PoE+ compatible hub)
* Connecting AW-RP50 and
AW-XXXX
via a hub: Straight cable, Category 5 or higher, Up to 100m
2.
Operate AW-RP50 to set up the connection with
AW-XXXX
.
Press MENU button. - (Fig. 1-A)
Press [10] SYSTEM button. - (Fig. 1-B) * “[1] CAMERA CTL” will be displayed on the LCD screen. - (Fig. 2)
* If it is not displayed, turn F1 dial to make “[1] CAMERA CTL” appear.
While “[1] CAMERA CTL” is displayed on the LCD, press F1 dial. – (Fig. 1-C)
(“[1] CAM1” will be displayed on the upper half, and the connection method (default: [NoAsign]) on the
lower half of the LCD screen.)
* If it is not displayed, turn F1 dial to make [CAM1] appear.
④
Turn F2 dial to select [Network], then press F2 dial to determine the setting. – (Fig. 1-D)
After the setting-up is completed, LED button 1 (CAM1) in the picture below (AW-RP50 CAMERA STATUS /
SELECTION Area) lights up according to the camera’s power status. If the camera is in STANDBY mode (power
OFF: factory default), it lights up in orange. If in POWER ON mode (power ON), it lights up in green.
* When the camera is in STANBY mode, the Power-ON operation needs to be done. (Please see “3. Turn
AW-XXXX
on” below.)
(AW-RP50: CAMERA STATUS/SELECTION Area)
1.CAM1
Network
［
1
］
CAMERA CTL
MENU ON
⇒
Select [10]
Press F1
Turn F2 to select
⇒
Press F2 to determine
Controlling (One)
PTZ
Camera via AW-RP50
Controller
After setting up, this lights up
according to the camera’s
power status.
* If it does not light up, please check the following points.
(Figure 1) (Figure 2)
（
A
）
（
B
）
（
C
）
（
D
）
①
Check the connection state of LAN cable or whether you are using a cable that meets the specifications.