Panasonic AVCCAM AG-AF100AP, Руководство по эксплуатации

Страница: 38 / 52

38
Removing SD Memory Card
1
Lift the viewfinder up, and slide the card slot
cover OPEN lever right to open.
• Ensure that the SD Memory Card access
lamp is not flashing orange before opening
the cover.
2
Press the center of the SD Memory Card so
that it pops out slightly, and pull the card
straight outwards.
SD Memory Card access lamp
• Do not remove the SD Memory Card or switch off
the power in the following circumstances. Doing
so may damage your SD Memory Card.
1) While the SD Memory Card access lamp is still
flashing orange after an SD Memory Card has
been inserted.
2) While the SD Memory Card access lamp is
flashing such as during recording or during
recording finalization.
Protecting SD Memory Cards
Move the write-protect switch on the SD Memory
Card to the “LOCK” position to prevent recorded
contents being accidentally erased from the card.
32
LOCK
Write-protect
switch
Repairing SD Memory Cards
Never remove the SD Memory Card or disconnect
the battery or DC cord while the SD Memory Card
access lamp is flashing, as doing so may damage
the SD Memory Card. In the event that the SD
Memory Card has been removed while the SD
Memory Card access lamp was flashing, or that
the battery or DC cord has been disconnected
during recording or the recording finalization
process, a repair verification screen will be
displayed the next time the power is switched on in
order to allow errors to be repaired.
Select YES to begin repairing. When repairing is
complete, “REPAIR FINISHED” will be displayed, and
the camera will switch to the recording paused screen.
Select NO to switch directly to the recording
paused screen without repairing.
• Memory cards cannot be repaired with the camera
if NO is selected, but can still be repaired by using
the AVCCAM Restorer
*
contents repair software.
• An SD Memory Card on which an error occurred
can be repaired by using either the camera
that was used for the shooting, or the AVCCAM
Restorer contents repair software.
• A repair confirmation message may be displayed
after inserting an SD Memory Card which has no
error, but repair will not be performed even when
YES or NO is selected.
• Repair may take up to 20 minutes or so depending
on the places where the errors occurred on the card.
• Use a battery with an adequate charge or the AC adaptor.
• If the repair operation has failed, “SYSTEM
ERROR TURN POWER OFF” will be displayed.
In this case, please use the AVCCAM Restorer
contents repair software.
Depending on the status of the data, it may not be
possible to restore all data completely. In this case,
it will no longer be possible to play back the clips
that were recorded before the power was turned off.
• Clips with a total recording time of less than 10
seconds may not be able to be repaired.
• Indexes attached during recording cannot be repaired.
*
AVCCAM Restorer is included on the supplied
CD-ROM.
For details on how to install it, refer to install.txt.
For details on how to use it, read the operating
instructions (PDF file).
The AVCCAM Viewer can also be downloaded
from the following website.
http://pro-av.panasonic.net/
Basic shooting operations (continued)