Panasonic AFP7CPS4E, Руководство пользователя

Страница: 29 / 139

3.2 Wiring of COM Port Terminal Block
3-5
3.2.3 Wiring Method

Wiring method
(1) Remove a portion of the wire’s insulation.
(2) Insert wire into terminal hole until it stops. Tighten screw clockwise to fix wire in place.
(The tightening torque: 0.22 to 0.25 N·m (2.3 to 2.5 kgf·cm))

Precautions on wiring
The following precautions should be observed, to avoid broken or disconnected wires.

When removing the wire’s insulation, be careful not to scratch the core wire.

Do not twist the wires to connect them.

Do not solder the wires to connect them. The solder may break due to vibration.

After wiring, make sure stress is not applied to the wire.

In the terminal block socket construction, if the wire is fastened upon counter-clockwise
rotation of the screw, the connection is faulty. Disconnect the wire, check the terminal hole,
and then re-connect the wire.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com