36
37
Parameter setting
Selecting the entry location of the parameter to be edited allows the parameter information to be displayed in
the message box. Parameter setting should be performed on the basis of the parameter information displayed
in the message box.
Range contents of parameter information
Indication
Range
figure (1) to figure (2)
Range from figure (1) or more to figure (2) or less
$$IPv4
IP address (including the case that IP is not set)
$$ character count
Limit of character count (no limit when the character count is 0)
Setting value (1), setting value (2),
setting value (3)...setting value (N)
Any of setting values (1) to (N)
Parameter check
After parameter editing, selection of another parame-
ter allows the parameter check function to be acti-
vated. The function checks that the parameter was
appropriately edited, and if the editing is inappropri-
ate, the entry area of the edited parameter becomes
red and an error pop-up is displayed.
Parameter editing again appropriately changes the
color of the entry area back to the previous color.
Apply the settings
To apply the settings after editing each parameter,
click the [Apply] button.
If the setting is appropriate, the parameter can be set,
however, if the setting is not appropriate, an error
pop-up is displayed and the parameter cannot be set.
Selection
Selection
