Panametrics DigitalFlow GC868, Руководство для стартапов

Страница: 51 / 90

DigitalFlow™ GC868 Startup Guide (1 and 2-Channel) 2-2
Chapter 2. Initial Setup
2.3 Accessing the
User Program
To access the
User Program
, press the [PROG] key on the keypad.
Note: If the security feature is active, enter the password and press [ENT] to enter
the
User Program
. See the
SECUR
submenu section in Chapter 1 of the
Programming Manual for more information on the security feature.
For a 1-Channel Model GC868, the measurement mode screen is replaced by the
following initial programming mode screen:
For a 2-Channel Model GC868, the following two-step sequence is required to reach
the initial programming screen:
Only the submenus ACTIV , SYSTM and PIPE are discussed in this manual. Refer to the
Programming Manual for information on the other submenus.
Note:
In this manual, only the programming of Channel 1 will be described. To
program Channel 2, simply repeat the same procedures presented for
Channel 1.
PROGRAM Start
At the User Program screen
shown, press [F1] and proceed
to
Activating a Channel
on
page 2-3 for instructions.
PROGRAM
status
ACTIV SYSTM PIPE I/O
PROGRAM Start
Press [F1] or [F2] to select the
submenu for Channel 1 or
Channel 2, respectively, from
the option bar.
PROGRAM
Channel 1
CH1 CH2 GLOBL SAVE
Chan 1 PROGR Start
At the User Program screen
shown, press [F1] and proceed
to
Activating a Channel
on
page 2-3 for instructions.
Channel PROGRAM
status
ACTIV SYSTM PIPE I/O