Palmgren TU 2506, Руководство по эксплуатации

Страница: 27 / 98

Page 27
TU2506
ǀ
TU2807V US
3.6 Optional machine accessories
WARNING!
Risk by using improper workpiece clamping fixtures or by operating the machine with
inadmissible speed.
Only use the clamping fixtures (e.g. lathe chuck) which had been delivered together with
the machine or as optional equipment offered by
company
.
Use the working clamping fixtures only in the provided admissible speed range.
Workpiece clamping fixtues must only be modified according to the recommendations of
company
or of the clamping fixture manufacturer.
3.7 Mounting instructions
3.7.1 Mounting instruction chuck flange
Clean the flange and spindle nose, put the flange onto the spindel nose screws.
Measure the mounting hole of the chuck and turn the flange to a diameter as a H7 fit.
Put the jaw chuck onto the flange.
INFORMATION
Position the chuck on the spindle nose step and tap it in with rubber-faced hammer (distribute
uniformly easy strokes over the front panel).
Tighten studs nuts alternatingly and uniformly.
Do not ever tighten studs when installing them into the chuck flange as this could deform
chuck's body - jaws will lock in place or would be hard to move.
Furthermore, radial runout can occur.
Recutting chuck jaws is inadmissible!
Description Item No. Description Item No.
TU2506 TU2807V
• Surface plate 240mm (9.5") 344 1352 • Surface plate 265mm (10.4") 344 1452
• Steady rest 344 1315 • Steady rest 344 1415
• Movable rest 344 1310 • Movable rest 344 1410
• Chuck flange 160mm 344 1413
TU2506 and TU2807V
• Chuck flange 125mm 344 1311
• 4-Jaw Chuck 125mm 344 2812
• Collet chuck holder ER 25 344 1305
• Collet chuck holder ER 32 344 1306
• Quick change tool holder
SWH 1-A 338 4301